How to Build 10 Foot PVC Ballet Barres

This article comes from Kelly on how to make full-sized PVC ballet barres, great for a studio or at home.

 

This is the instructions/ measurements for ours that I made for Pulse Dance Studio in Bedford:

Barre measurements:
59.5″ cross bars (x2)
9.25″ spacer (x3)
27″ (adult) 16.25″ (baby) legs (x3)
10.75″ feet (x6)
(4) 90 deg. cross fitting
(3) 90 deg. tee fitting
(8) 90 deg. elbow fitting
(28) 8×3/4 screws
(1) can of PVC glue
1 1/4 in PVC pipe was used when we made these (it was the heavier kind from Lowes)
Cut PVC carefully to make everything even. I used a table miter saw. Dry fit and mark. Glue top elbow, spacer, and tee together (we didn’t glue to leg so we could swap out legs if we needed more tall ones or more short ones) glue feet. Dry fit bars and legs and drill holes straight through fitting and bar for screws so they can be disassembled if needed. Put in screws, you’re done!
Makes one ten foot double barre out of PVC 🙂
__________________________________________________
Skip to toolbar